It is different from the general mixing furnace, generally should meet the following three requirements: 1. It can control the temperature of the liquid metal during drawing, so that the molten metal is always maintained within a certain temperature range, so as to ensure the normal production of continuous casting and the best quality of the ingot. Vacuum Heat Treatment Furnace For Molds 2. The furnace is required to vibrate back and forth within a certain range. For certain alloys, horizontal continuous casting must be vibrated to obtain good ingot surface quality and crystalline structure. The amplitude range is 0-15 mm, and the vibration frequency is 0-200 times per minute. Copper wire workshop design and vacuum heat treatment 3. The front of the furnace body should be easy to install the mold, so that the liquid metal in the furnace can directly enter the mold in a short distance. Casting Vacuum Heat Treatment Process Therefore, the holding furnace is made into a horizontal power frequency induction furnace with an iron core with a slightly square body. This kind of furnace can be tilted and rotated and cannot be tilted. Although the structure of the tiltable furnace is more complicated , but can prevent the danger of liquid metal shock during leakage. The Function And The Production Of Ceramic Bulletproof Vest

A roasting stove is a stove used in southern winters to keep warm. C/C composite brake material Also known as electric oven, electric fire bucket, foot warmer, etc.! It can be widely used in various civil and public buildings such as residences, offices, hotels, hospitals, schools, and simple mobile houses. It mainly sends warmth in the form of far-infrared radiation and thermal diffusion. Also known as electric oven, electric fire bucket, foot warmer, etc.! Vacuum Brazing Technology of Static Guide Vane Ring It can be widely used in various civil and public buildings such as residences, offices, hotels, hospitals, schools, and simple mobile houses. It mainly sends warmth in the form of far-infrared radiation and thermal diffusion.conformity.

1. This type of drying box should work indoors and be installed smoothly. 2. The power input should be equipped with a dedicated front-level on-off switch and connected to a good ground wire. Die Steel & Vacuum Heat Treatment News 3. Take in baking objects: Do not hit the part of the temperature controller that extends into the studio to prevent damage to the temperature controller and cause failure. Wave spring vacuum heat treatment 4. When it is newly purchased or put aside for a long time, it should be baked at a low temperature of 80-100 ℃ for two hours before starting to increase the temperature, so as to facilitate the leakage of moisture, enhance the insulation performance and prolong the life of the porcelain parts. 5. You must check the power supply, voltage, and power supply wiring before you can use it. 6. The thermal element probe for instrument temperature control should be inserted into the working room from the temperature measuring hole of the left line, and should not be inserted through the center hole of the air valve on the top of the box, so as not to affect the use. Vacuum Heat Treatment of Hand Hacksaw Blades 7. When the drying box is used for the first time, please observe it frequently to avoid overheating and drying the workpiece and causing losses. 8. If you feel that the thermal inertia is slightly larger, you can turn off a group of heaters to reduce the heating power and prevent overheating caused by excessive inertia. 9. In case of failure, please professional electrician to overhaul. 10. Do not bake explosive, flammable and volatile items in this box to prevent explosion. Surgical instruments stainless steel vacuum heat treatment 11. When leaving the factory, there are two shelves in the studio, one instruction manual and one certificate of conformity.